How do I adjust my headlights from side to side?

How do I adjust my headlights from left to right?

One screw will adjust the headlight up/down while the other will adjust left/right – keeping your eye on the beam on the wall slowly turn one of the screws to determine which direction it’s adjusting, if it’s not the way you want turn it back to the original location and use the other screw.

How do you change a headlight to the left?

How to change a headlight bulb in 5 steps

  1. Power your car down. To ensure safety, turn off your car and take the keys out of the ignition.
  2. Open engine compartment. …
  3. Disconnect the headlight bulb power wires. …
  4. Unscrew the old headlight. …
  5. Screw in the new headlight bulb.

How do I check my headlight beam pattern?

One line should go vertically from the top of the circle to the bottom and the other should go horizontally from side to side. Where the two lines meet in the middle is the centre of your headlights. The centre of both plus signs should be the same height, so use a tape measure to check.

What position should my headlights be?

The top of the low beam shining on the wall should be at or slightly below the height of the center of the headlight lens for most vehicles. You should expect the light pattern to be higher on the right side (passenger side) to illuminate road signs and lower on the driver’s side to prevent blinding other drivers.

IT IS SURPRISING:  How do I reconnect my merkury smart bulb?